最新下载
热门教程
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
VNX for File启用FC端口时提示“Error 14: The Block Enabler is not present”
时间:2016-07-21 编辑:简简单单 来源:一聚教程网
故障现象:
输入以下命令时,有如下报错:
# /nas/sbin/nas_hw_upgrade -option -enable -mpfsis | -mpfsfc | -clariionfc | -clariionis | -fc_option -enable
Checking if running on primary CS...yes
Checking if running as root...yes
Checking for integrated system...yes
Checking if model is supported...yes
Checking if backend is supported...yes
Checking if BlockEnabler is installed...no
Error 14: The Block Enabler is not present, it is required for this upgrade to proceed.
输入以下命令查看,发现该系统为纯File
# /nas/sbin/model -option -list
OPTION ENABLED: NOT AVAILABLE -->说明是File Only
原因分析:
VNX File Only 不能添加FC启用标志,也不能用“nas_hw_upgrade”命令添加任何硬件升级标志,必须从File Only升级到Unified才可以。
解决方案:
使用USM导入Unified的NDU License或是通过命令行导入Enabler,将File Only升级成Unified即可。
例如:
# /nasmcd/sbin/navicli –h ndu –messner –install -UnisphereBlock
相关文章
- 如何打开445端口 打开445端口的方法 07-09
- 搜房帮怎么确定购买端口已开 购买端口是否打开查看教程 04-03
- tplink怎么判断虚拟服务器端口映射是否成功? 05-20
- tplink交换机的”汇聚上联模式”是端口汇聚吗 05-19
- 部署MRTG监控H3C交换机端口流量教程 07-10
- 安全狗屏蔽端口怎么解除?取消加入安全策略方法 05-27